FixVault
Home › Scion › 2009 › xD Standard › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Interior › Fuel Lid Lock Control › Removal

Fuel Lid Lock Control: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag) 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
  2. REMOVE FRONT SEAT ASSEMBLY LH  (See REMOVAL )
  3. REMOVE DECK BOARD ASSEMBLY  (See REMOVAL  )
  4. REMOVE NO. 1 REAR SEAT LEG COVER LH  (See REMOVAL )
  5. REMOVE NO. 2 REAR SEAT LEG COVER LH  (See REMOVAL )
  6. REMOVE REAR SEAT ASSEMBLY LH  (See REMOVAL )
  7. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL  )
  8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL  )
  9. REMOVE COWL SIDE TRIM BOARD LH  (See REMOVAL  )
  10. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL  )
  11. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL  )
  12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL  )
  13. REMOVE LAP BELT OUTER ANCHOR COVER  (See REMOVAL )
  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH  (See REMOVAL )
  15. REMOVE CENTER PILLAR LOWER GARNISH LH  (See REMOVAL  )
  16. REMOVE REAR DECK TRIM COVER  (See REMOVAL  )
  17. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY  (See REMOVAL  )
  18. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH  (See REMOVAL )
  19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH  (See REMOVAL  )
  20. DISCONNECT FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY 
    1. Remove the bolt.
    2. Disengage the claw and disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.
      Fig 1: Disconnecting Fuel Lid Lock Open Lever
      G05403783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY 
    1. Disconnect the fuel lid lock control cable sub-assembly as shown in the illustration.
      2. Fig 2: Disconnecting Fuel Lid Lock Control Cable
      G05403784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamp and disconnect the fuel lid lock control cable sub-assembly as shown in the illustration.
    3. Disengage the 5 clamps and remove the fuel lid lock control cable sub-assembly.
      Fig 3: Identifying Fuel Lid Lock Control Cable Clamps
      G05403785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the fuel lid lock control cable sub-assembly by turning it counter-clockwise and pulling it, as shown in the illustration.
      Fig 4: Removing Fuel Lid Lock Control Cable
      G05403786Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault