FixVault
Home › Scion › 2009 › xD Standard › Repair and Diagnosis › Engine Mechanical › Engine Exhaust Assembly › Exhaust Manifold › Removal

Exhaust Manifold: Removal

  1. REMOVE AIR FUEL RATIO SENSOR 

    Refer to the procedures under "REMOVE AIR FUEL RATIO SENSOR" (See REMOVAL ).

  2. REMOVE ENGINE UNDER COVER RH 
  3. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    Refer to the procedures under "REMOVE FRONT EXHAUST PIPE ASSEMBLY" (See REMOVAL  ).

  4. DRAIN AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle) 
  5. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle) 
  6. REMOVE FRONT WHEEL 
  7. REMOVE FRONT AXLE SHAFT RH NUT  (See REMOVAL )
  8. REMOVE FRONT SPEED SENSOR RH  (See REMOVAL )
  9. REMOVE TIE ROD END SUB-ASSEMBLY RH  (See REMOVAL )
  10. REMOVE FRONT STABILIZER LINK ASSEMBLY RH  (See REMOVAL )
  11. REMOVE NO. 1 FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH  (See REMOVAL )
  12. SEPARATE FRONT AXLE ASSEMBLY RH  (See REMOVAL )
  13. REMOVE DRIVE SHAFT ASSEMBLY RH  (See DISASSEMBLY )
  14. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Remove the 4 bolts and remove the No. 1 exhaust manifold heat insulator.
      Fig 1: Locating No. 1 Exhaust Manifold Heat Insulator Bolts
      G05399604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE MANIFOLD STAY 
    1. Remove the 3 bolts and remove the manifold stay.
      Fig 2: Locating Manifold Stay Bolts
      G05399605Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE EXHAUST MANIFOLD 
    1. Remove the 5 nuts and remove the exhaust manifold.
      Fig 3: Locating Exhaust Manifold Nuts
      G05399606Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Remove the 3 bolts and remove the No. 2 exhaust manifold heat insulator.
      Fig 4: Locating No. 2 Exhaust Manifold Heat Insulator Bolts
      G05399607Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault