FixVault
Home › Scion › 2012 › xB Standard Trans › Repair and Diagnosis › Electrical › Gauges › Meter (Service Information) › Light Control Rheostat › Installation › Installation

Light Control Rheostat: Installation: Installation

  1. INSTALL LIGHT CONTROL RHEOSTAT 
    Fig 1: Identifying Light Control Rheostat Claws
    GTY166990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Engage the 2 claws to install the light control rheostat.
  2. INSTALL NO. 1 SWITCH HOLE BASE  . Refer to INSTALLATION - Step 11
  3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 12
  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  . Refer to INSTALLATION - Step 13
  5. INSTALL COMBINATION METER ASSEMBLY  See step  1
  6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  . Refer to INSTALLATION - Step 16
  7. INSTALL INSTRUMENT CLUSTER FINISH LOWER PANEL  . Refer to INSTALLATION - Step 17
  8. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 19
  9. INSTALL FRONT PILLAR GARNISH LH  . Refer to INSTALLATION - Step 26
  10. INSTALL FRONT PILLAR GARNISH RH  . Refer to INSTALLATION - Step 25
  11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  . Refer to INSTALLATION - Step 23
  12. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  . Refer to INSTALLATION - Step 22
  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

About FixVault