Skid Control Buzzer Circuit: Procedure

1. Check if the CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .

   Result

   Result	Proceed to
   DTC not output	A
   DTC output	B

B → See step   6 

A: Go to next step 

1. Connect a Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test mode on the Techstream. Refer to DATA LIST / ACTIVE TEST .
   ABS/VSC/TRAC:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Buzzer	Skid control buzzer	Buzzer ON / OFF	Buzzer can be heard

4. Check that the buzzer sounds or stops in accordance with the Techstream.

   Result

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

B → See step   5 

A: Go to next step 

1. Turn the ignition switch to OFF.
2. Replace the combination meter. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test mode on the Techstream. Refer to DATA LIST / ACTIVE TEST .
   ABS/VSC/TRAC:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Buzzer	Skid control buzzer	Buzzer ON / OFF	Buzzer can be heard

4. Check that the buzzer sounds or stops in accordance with the Techstream.

   Result

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

B → END 

A → See step   5