FixVault
Home › Scion › 2014 › tC Automatic Trans › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (Diagnostic Codes) › Automatic Transaxle System › DTC P062F: Internal Control Module EEPROM Error [07/2013 - 12/2013] › Procedure

DTC P062F: Internal Control Module EEPROM Error [07/2013 - 12/2013]: Procedure

  1. CHECK DTC OUTPUT (IN ADDITION TO DTC P062F) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear DTCs. Refer to DTC CHECK / CLEAR [05/2013 - 01/2014] .
    5. Turn the ignition switch off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    8. Connect the cable to the negative (-) battery terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the ignition switch to ON.
    11. Turn the Techstream on.
    12. Enter the following menus: Powertrain / ECT / Trouble Codes.
    13. Read the DTCs using the Techstream.

      Result

      Display (DTC output) Proceed to
      P062F is output A
      No DTC B

    B → See step   2 

    A → See step   3 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [05/2013 - 01/2014] 
  3. REPLACE TCM. Refer to  REMOVAL [05/2013 - 01/2014] 
About FixVault