FixVault
Home › Scion › 2016 › iA Standard Trans › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Control System - Service Information › Camshaft Position Sensor › Removal [07/2015 - ] › Procedure

Removal [07/2015 - ]: Procedure

  1. REMOVE CAMSHAFT POSITION SENSOR 
    1. Disconnect the negative battery cable.

      Refer to REMOVAL [07/2015 - ]

    2. Remove the plug hole plate.

      Refer to REMOVAL [07/2015 - ]

    3. Remove the intake manifold.

      Refer to REMOVAL [07/2015 - ]

    4. Disconnect the CMP sensor connector.
    5. Remove the bolt.
      GTY491990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a CMP Sensor
      *b Bolt
      *c Vehicle Front
      • Non-reusable part
      N*m (kgf*cm, ft.*lbf): Specified torque
      Oil
    6. Remove the CMP sensor.
About FixVault