Inspection [06/2015 - ]: Procedure
- INSPECT SPORT SWITCH (COMBINATION SWITCH ASSEMBLY)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 (MSW1) - 7 (E) Pressed Below 50 Ω Not pressed 10 kΩ or higher If the result is not as specified, replace the SPORT switch (combination switch assembly).
*a Component without harness connected
(SPORT Switch (Combination Switch Assembly)) - Apply battery voltage between the terminals of the switch and check the illumination condition of the SPORT switch (combination switch assembly).
*a Component without harness connected
(SPORT Switch (Combination Switch Assembly))Standard
Measurement Condition Specified Condition Battery positive (+) → 2 (ILL+)
Battery negative (-) → 6 (ILL-)Illuminates If the result is not as specified, replace the SPORT switch (combination switch assembly).
- Measure the resistance according to the value(s) in the table below.