FixVault
Home › Subaru › 1974 › GL Automatic Trans › Repair and Diagnosis › Electrical › Starter › Starters - NIPPONDENSO › Overhaul › Disassembly

Starters - NIPPONDENSO: Overhaul: Disassembly

  1. Disconnect field coil wire from starter solenoid main terminal and remove the two solenoid attaching bolts. Remove solenoid by moving it up and down to unhook unit from drive lever.
  2. Remove bearing cover and pull out armature shaft lock plate, washer, seal and spring.
  3. Remove through bolts, commutator end frame, brush holder and yoke.
  4. Remove drive lever set bolt, rubber piece, plate, armature and drive lever from housing.
  5. Remove pinion stop collar from armature shaft end, and remove starter clutch.
About FixVault