FixVault
Home › Subaru › 1984 › DL 2D Hatchback › Repair and Diagnosis › Engine Performance › Ignition System › Ignition System - NIPPONDENSO Electronic › Overhaul › Reassembly

Ignition System - NIPPONDENSO Electronic: Overhaul: Reassembly

  1. Assemble in reverse order of disassembly. Lightly grease signal rotor (reluctor) inner surface.
  2. Install on shaft aligning proper mark on stopper plate. Install new drive pinion and pin.
  3. When installing breaker plate, align 4 clips of plate with 4 grooves in housing.
  4. When replacing pinion, replace pin and drive pinion as a set. Peen both ends of pin in a vise. Adjust air gap between signal rotor and pick-up coil. Install distributor and adjust timing.
About FixVault