Justy (PFI)
- With ignition off, disconnect Throttle Position Switch (TPS) connector. Using an ohmmeter, measure resistance between terminals No. 2 and 3 with throttle fully closed and then with throttle fully open. See Figure . Record reading.
- Ensure readings are as specified. See 3-CYLINDER THROTTLE POSITION SWITCH RESISTANCE (PFI) table. If necessary, loosen attaching screws and rotate TPS until correct resistance is obtained. Replace TPS if resistance cannot be adjusted to specification.
3-CYLINDER THROTTLE POSITION SWITCH RESISTANCE (PFI)
| Application | Ohms | |
|---|---|---|
| Terminals No. 2 & 3 | ||
| Throttle Fully Closed | Less Than One | |
| Throttle Fully Open | Infinite | |