Crossbar (Roof Rack): Installation

Rotate lower clamp of each end support about 90 degrees downward.
Set crossbar so that front direction arrow on the right top face of crossbar points in the direction of vehicle front, and place crossbar end support at position 152.4 mm (6.00 in) back from joint of front roof rail support and roof rail.
Length A:
1. 152.4 mm (6.00 in)
  
  Fig 1: Identifying Length (A) For Crossbar (Roof Rack)
Set crossbar so that front direction arrow on the right top face of crossbar points in the direction of vehicle front, and place crossbar end support at position 152.4 mm (6.00 in) back from joint of rear roof rail support and roof rail.
Length B:
1. 152.4 mm (6.00 in)
  
  Fig 2: Identifying Length (B) For Crossbar (Roof Rack)
Tighten end support and lower clamp using TORX(R) bolt T30.