FixVault
Home › Subaru › 2000 › Outback Base, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Overhaul - 4-ATAXLE › Component Disassembly & Reassembly › Differential Case Assembly › Disassembly

Differential Case Assembly: Disassembly

  1. Press off taper roller bearing using Remover (498077000 ) and press. Secure differential case in vise. Remove ring gear bolts and ring gear and separate differential cases.
  2. Drive out roll pin and remove pinion shaft from case. Remove pinion gears, side gears and thrust washers. See Figure .
About FixVault