Operational Guidelines Of The ABS Sequence Control With Select Monitor
WARNING: This page is about a different car, the 2001 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- In the event of any trouble, the sequence control may not be operative. In such a case, activate the sequence control, see OPERATIONAL GUIDELINES OF THE ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR .
- When the diagnosis terminal is connected to the diagnosis connector, the sequence control will not operate.
- Connect select monitor to data link connector beside driver's seat instrument panel lower cover.
- Turn ignition switch to ON.
- Turn select monitor switch to ON.
- Put select monitor to (ABS/TCS) mode.
- When (Function check sequence) is selected, "ABS sequence control" will start.
- The message `Press Brake Pedal Firmly' is displayed as follows:
- When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lb).
- When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2 , 498 psi).
CAUTION: Do not depress the clutch pedal. - When the message "Press YES" is displayed, press YES key.
- Operation points will be displayed on select monitor.