FixVault
Home › Subaru › 2000 › Outback Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 33 (Overhaul Automatic Transmission) › Inhibitor Switch › Installation

Inhibitor Switch: Installation

WARNING: This page is about a different car, the 2001 Subaru Outback, 2001 Subaru Legacy, 2001 Subaru Impreza, and 2001 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install inhibitor switch to transmission case.
    Fig 1: Installing Inhibitor Switch To Transmission Case
    G02037028
  2. Move range select lever to neutral position.
  3. Using ST, tighten bolts of inhibitor switch. ST 499267300 STOPPER PIN
    Fig 2: Moving Range Select Lever To Neutral Position
    G02037029
  4. Install select cable to range select lever.
  5. Install plate assembly to transmission.

    Tightening torque: 

    1. T:  24.5 N-m (2.50 kgf-m, 18.1 ft-Ib)
      Fig 3: Installing Plate Assembly
      G02037030
  6. Install snap pin to range select lever.
    Fig 4: Installing Snap Pin
    G02037031
  7. Install center exhaust pipe.
  8. Connect inhibitor switch connector.
    Fig 5: Connecting Inhibitor Switch Connector
    G02037032
  9. Install air intake chamber and duct.
About FixVault