FixVault
Home › Subaru › 2001 › Outback Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 127 (A/T & M/T Control Systems) › Select Lever › Removal

Select Lever: Removal

WARNING: This page is about a different car, the 2002 Subaru Outback and 2002 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the select lever to the "N" position.
  2. Remove rear exhaust pipe and muffler. 2.5 L model

    Refer to REMOVAL , Rear Exhaust Pipe and REMOVAL , Muffler 3.0 L model

    Refer to REMOVAL , Rear Exhaust Pipe and REMOVAL , Mufflers.

  3. Remove heat shield cover.
    Fig 1: Removing Heat Shield Cover
    G02960734Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect cable from select lever and then remove cable bracket.
    Fig 2: Disconnecting Cable From Select Lever & Removing Cable Bracket
    G02960735Courtesy of SUBARU OF AMERICA, INC.
  5. Remove console box. Refer to REMOVAL , Console Box.
  6. Disconnect the connectors, then remove the four bolts to take out the selector lever assembly from the body.
Fig 3: Removing Selector Lever Assembly From Body
G02960736Courtesy of SUBARU OF AMERICA, INC.
About FixVault