Knock Sensor: Installation

WARNING: This page is about a different car, the 2003 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install knock sensor to cylinder block.
1. Tightening torque: 25 N.m (2.5 kgf-m, 18 ft-lb)
NOTE: For the knock sensor's installation angle, refer to, See Fig 1.

Fig 1: Installing Knock Sensor To Cylinder Block
Courtesy of SUBARU OF AMERICA, INC.
Connect knock sensor connector.
Install intake manifold. < Ref. to INSTALLATION , Intake Manifold.>
Connect battery ground cable.

Fig 2: Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.