FixVault
Home › Subaru › 2001 › Outback Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 20 (Air Bag Restraint Systems) › Diagnostic Tests › Code 11

Code 11

WARNING: This page is about a different car, the 2002 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding, see AIR BAG SAFETY PRECAUTIONS . After repairs are complete, check AIR BAG warning light to verify system is functioning correctly. See SYSTEM OPERATION CHECK .
  1. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove instrument panel lower cover. Disconnect lower clockspring connectors AB3 and AB8. See Figure. Remove glove box and disconnect passenger-side air bag module connectors AB9 and AB10. Connect test harness "F" (98299FC010), connector 1F to connector AB8. See Figure. Disconnect air bag control module connector AB6. Connect connector AB6 to test harness "I" (98299FC040) or I2 (98299FC041), connector 1I. See Figure or Figure .
  2. Measure resistance between test harness "I" or I2, connector 2I, terminal No. 1 and test harness "F", connector 3F, terminal No. 3. If resistance is less than 10 ohms, go to next step. If resistance is 10 ohms or more, replace air bag system main harness and go to step  7.
  3. Measure resistance between test harness "I" or I2, connector 2I, terminal No. 4 and test harness "F", connector 3F, terminal No. 4. If resistance is less than 10 ohms, go to next step. If resistance is 10 ohms or more, replace air bag system main harness and go to step  7.
  4. Measure resistance between test harness "I" or I2, connector 2I, terminals No. 1 and 4. If resistance is more than one megohm, go to next step. If resistance is one megohm or less, replace air bag system main harness and go to step  7.
  5. Measure resistance between ground and test harness "I" or I2, connector 2I, terminal No. 4. If resistance is more than one megohm, go to next step. If resistance is one megohm or less, replace air bag system main harness and go to step  7.
  6. Measure resistance between ground and test harness "I", connector 2I, terminal No. 1. If resistance is more than one megohm, replace air bag control module and go to next step. See CONTROL MODULE  under REMOVAL & INSTALLATION. If resistance is one megohm or less, replace air bag system main harness and go to next step.
  7. Reconnect system components and activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Clear air bag system codes. See CLEARING CODES  under DIAGNOSTICS. Check for normal air bag system operation. See SYSTEM OPERATION CHECK .
About FixVault