ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Installation
- Install the ABSCM&H/U bracket.
- Tightening torque: 33 N.m (3.4 kgf-m, 24.6 ft-lb)
- Apply a coat of rust-preventive wax (Nippeco LT or GB) to the bracket attaching bolt.
- Align the width across flat portion of ABSCM&H/U side stud bolt with the bolt hole groove on bracket, and then install the ABSCM&H/U.NOTE: Confirm the specification mark of ABSCM&H/U.
- Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
- Connect the brake pipes to their correct ABSCM&H/U connections.
- Tightening torque: 15 N.m (1.5 kgf-m, 10.8 ft-lb)
- Using the cable clip, secure the ABSCM&H/U harness to bracket.
- Connect the connector to ABSCM&H/U.NOTE:
- Be sure to remove all foreign matter from inside of the connector before connecting.
- Ensure that the ABSCM&H/U connector is securely locked.
- Connect the ground cable to ABSCM&H/U, and then apply anti-corrosive wax.
- Install the air intake duct.
- Bleed air from the brake system.