Reduction Driven Gear: Installation
- Set the select lever to "P" range.
- Using a plastic hammer, install reduction driven gear assembly and new washer, and tighten new drive pinion lock nut.
- Tightening torque:
100 N.m (10.2 kgf-m, 73.8 ft-lb)
Courtesy of SUBARU OF AMERICA, INC.
- After tightening, stake the lock nut securely.
- Combine the transmission case with the extension case, and install rear vehicle speed sensor. Refer to
INSTALLATION .
- Install the transmission assembly to vehicle. Refer to
INSTALLATION , Automatic Transmission Assembly.