Vehicle Speed Sensor: Installation
NOTE:
- Discard the vehicle speed sensor and after removal, replace with a new one.
- Ensure the sensor mounting hole is clean and free of foreign matter.
- Align the tip end of key with key groove on end of speedometer shaft during installation.
- Hand tighten the vehicle speed sensor.
- Tighten the vehicle speed sensor using suitable tool.
- Tightening torque: 5.9 N.m (0.6 kgf-m, 4.3 ft-lb)
- Connect the connector to vehicle speed sensor.
- Install the front, center exhaust pipes and muffler.
- Lower the vehicle.
- Connect the battery ground cable to battery.