FixVault
Home › Subaru › 2004 › Forester X, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 11 (Clutch System) › Master Cylinder › Installation

Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the master cylinder to body, and install the clutch pipe to master cylinder.
    NOTE: Check that the pipe is routed properly.

    Tightening torque: 

    1. T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb) 
    2. T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb) 
    Fig 1: Identifying Master Cylinder
    G00938093Courtesy of SUBARU OF AMERICA, INC.
  2. Apply a coat of grease to the clevis pin.
  3. Connect the push rod of master cylinder to clutch pedal, and install the new clevis pin and snap pin.
    Fig 2: Connecting Push Rod Of Master Cylinder To Clutch Pedal
    G00938094Courtesy of SUBARU OF AMERICA, INC.
  4. After bleeding air from the system, ensure that clutch operates properly. < Ref. to CLUTCH FLUID AIR BLEEDING .>
  5. Install the air cleaner case and air intake duct (Non-turbo model). < Ref. to INSTALLATION , Air Cleaner Case .> and < Ref. to INSTALLATION Air Intake Duct .>
  6. Install the intercooler (Turbo model). < Ref. to INSTALLATION , Intercooler .>
About FixVault