FixVault
Home › Subaru › 2004 › Impreza RS, Automatic › Repair and Diagnosis › Brakes › Traction Control › Abs › ABS Sequence Control › Operation › Abs Sequence Control With Diagnosis Connector

Abs Sequence Control With Diagnosis Connector

  1. Turn the ignition switch to OFF.
  2. Connect the diagnosis terminal to terminal No. 6 of the diagnosis connector beside driver's seat.
    Fig 1: Identifying ABS Sequence Control With Diagnosis Connector
    G00953186Courtesy of SUBARU OF AMERICA, INC.
  3. Turn the ignition switch to ON.
  4. Confirm that start code (code 11) is only displayed.
  5. Turn the ignition switch to OFF.
  6. Connect the diagnosis terminals to terminals No. 6 and No. 3 of diagnosis connector.
  7. Set the speed of all wheels at 4 km/h (2 MPH) or less.
  8. Turn the ignition switch to ON.
  9. Within 0.5 seconds after the ABS warning light goes out, depress the brake pedal and hold it depressed.
    NOTE: Engine must not operate.
  10. After completion of ABS sequence control, turn the ignition switch to OFF.
About FixVault