Operating Cylinder: Installation

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
NOTE: Before installing the operating cylinder, apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and operating cylinder.

Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)

Fig 1: Installing Operating Cylinder
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that clutch operates properly.

< Ref. to , CLUTCH FLUID AIR BLEEDING . >