FixVault
Home › Subaru › 2005 › Baja Base, Automatic › Repair and Diagnosis › Suspension › Wheel Alignment › Front Suspension › Front Ball Joint › Installation

Front Ball Joint: Installation

  1. Install ball joint onto housing.

    Tightening torque (Bolt): 

    50 N.m (5.1 kgf-m, 37 ft-lb) 

    CAUTION: Do not apply grease to tapered portion of ball stud.
  2. Connect ball joint to transverse link.

    Tightening torque (Castle nut): 

    39 N.m (4.0 kgf-m, 29 ft-lb) 

  3. Retighten castle nut further within 60° until a slot in castle nut is aligned with the hole in ball stud end, then insert new cotter pin and bend it around castle nut.
  4. Install front wheel.
About FixVault