FixVault
Home › Subaru › 2005 › Baja Base, Standard › Repair and Diagnosis › Brakes › Traction Control › Brakes - Abs › ABS Sequence Control › Operation › Abs Sequence Control With Select Monitor

Abs Sequence Control With Select Monitor

NOTE: In the event of troubles such as "ABS cannot communicate with Select Monitor", the sequence control will not activate. In such a case, perform trouble diagnosis. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
  1. Connect select monitor to data link connector under driver's seat instrument panel lower cover.
  2. Turn ignition switch ON.
  3. Turn select monitor switch ON.
  4. Put select monitor to "BRAKE CONTROL" mode.
  5. When "Function check sequence" is selected, "ABS sequence control" will start.
  6. The message "Press Brake Pedal Firmly" is displayed as follows:
    1. When using the brake tester, depress brake pedal with braking force of 981 N (100 kgf, 221 lb).
    2. When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2 , 498 psi).
    CAUTION: Do not depress the clutch pedal.
  7. When the message "Press YES" is displayed, press "YES" key.
  8. Operation points will be displayed on select monitor.
About FixVault