Section 13 (Starting/Charging Systems (H4SO)): Battery: Installation

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

Tightening torque:

3.4 N.m (0.35 kgf-m, 2.5 ft-lb)

NOTE:

Clean the battery cable terminals and apply grease to retard the formation of corrosion.
Connect the positive (+) terminal, and then connect the negative (-) terminal of battery.
Initial diagnosis of electronic control throttle is performed after battery installation. For this reason, start the engine after 10 seconds or more have elapsed since the ignition switch was turned to ON.