FixVault
Home › Subaru › 2005 › Baja Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 71 (Security And Locks) › Impact Sensor › Installation

Impact Sensor: Installation

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from ignition switch.
  2. Close all the doors, trunk lid and rear gate.
  3. Press the UNLOCK button of transmitter.
  4. Disconnect the ground cable from battery.
  5. Install the impact sensor.
  6. Connect the ground cable from battery.
  7. Change the setting of impact sensor using Subaru Select Monitor.
About FixVault