FixVault
Home › Subaru › 2005 › Baja Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 71 (Security And Locks) › Security System › Inspection › Check Security System Condition Memory

Check Security System Condition Memory

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from ignition switch.
  2. Close all the doors, trunk lid and rear gate.
  3. Open the hood.
  4. Press the LOCK button of transmitter, and then wait until the security indicator light flashes twice for 0.5 sec at intervals of 2 seconds.
  5. Disconnect the ground cable from battery.
  6. Connect the battery ground cable to battery.
  7. Check that the security indicator light blinks twice within 0.5 seconds in 2 seconds cycle. When it does not blink, replace the body integrated unit.
About FixVault