Ignition Key Lock: Inspection
- Remove the instrument panel lower cover.
- Remove the lower column cover.
- Unfasten the hold down clip which secures harness and disconnect the connector of ignition switch from body harness.
- Turn the ignition key plate to each position and check the continuity between terminals of ignition connector.
SWITCH POSITION
| Switch position | Terminal No. | Standard |
|---|---|---|
| LOCK | - | - |
| ACC No. | 1 and No. 2 | Less than 1 ohm |
| ON | No. 1 and No. 2 No. 1 and No. 4 No. 2 and No. 4 |
Less than 1 ohm |
| ST | No. 1 and No. 3 No. 1 and No. 4 No. 3 and No. 4 |
Less than 1 ohm |
If NG, replace the ignition switch.