FixVault
Home › Subaru › 2005 › Outback R › Repair and Diagnosis › External Pages › Different car › Section 15 (Engine Controls - Engine (Diagnostics) (H4SO)) › Subaru Select Monitor › Operation › Read Current Data For At.

Read Current Data For At.

WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Transmission Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of transmission type.
  4. On the << Transmission Diagnosis >> display screen, select the {Current Data Display & Save} and press the [YES] key.
  5. On the << Data Display Menu >> display screen, select the {Data Display} and press the [YES] key.
  6. Using the scroll key, move the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
      SUPPORT DATA LIST (AT CURRENT DATA)

      Contents Display Unit of measure
      Battery voltage Battery Voltage V
      Rear vehicle speed sensor signal Vehicle Speed #1 km/h or MPH
      Front vehicle speed sensor signal Vehicle Speed #2 km/h or MPH
      Engine speed signal Engine Speed RPM
      Automatic transmission fluid temperature signal ATF Temp. °C or °F
      Throttle position signal Throttle Sensor Voltage V
      Gear position Gear Position -
      Line pressure control duty ratio Line Pressure Duty Ratio %
      Lock up clutch control duty ratio Lock Up Duty Ratio %
      Transfer clutch control duty ratio Transfer Duty Ratio %
      Power supply for throttle position sensor Throttle Sensor Power V
      Torque converter turbine speed signal AT Turbine Speed RPM
      2-4 brake timing pressure control duty ratio 2-4B Duty Ratio %
      Intake manifold pressure sensor voltage Mani. Pressure Voltage V
      2 wheel drive switch signal 2WD Switch ON or OFF
      Stop lamp switch signal Stop Lamp Switch ON or OFF
      Anti lock brake system signal ABS Signal ON or OFF
      Cruise control system signal Cruise Control Signal ON or OFF
      Neutral/Parking range signal N/P Range Signal ON or OFF
      Reverse range signal R Range Signal ON or OFF
      Drive range signal D Range Signal ON or OFF
      3rd range signal 3rd Range Signal ON or OFF
      2nd range signal 2nd Range Signal ON or OFF
      1st range signal 1st Range Signal ON or OFF
      Shift control solenoid A Shift Solenoid #1 ON or OFF
      Shift control solenoid B Shift Solenoid #2 ON or OFF
      Torque control output signal #1 Torque Control Signal #1 ON or OFF
      Torque control output signal #2 Torque Control Signal #2 ON or OFF
      Torque control cut signal Torque Control Cut Sig. ON or OFF
      2-4 brake timing control solenoid valve 2-4 Brake Timing Sol. ON or OFF
      Low clutch timing control solenoid valve Low Clutch Timing Sol. ON or OFF
      Automatic transmission diagnosis indicator lamp AT Diagnosis Lamp ON or OFF
    NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL. For select monitor display details, refer to the following.
About FixVault