Read Current Data For Engine (OBD Mode)
WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
- On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
- On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after displayed the information of engine type.
- On the << Engine Diagnosis >> display screen, select the {OBD System} and press the [YES] key.
- On the << OBD Menu >> display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the << Data Display Menu >> display screen, select the {Data Display} and press the [YES] key.
- Using the scroll key, move the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.ENGINE SUPPORT DATA LIST (OBD MODE)
Contents Display Unit of measure Number of diagnosis code Number of Diag. Code - Malfunction indicator lamp status MI (MIL) ON or OFF Monitoring test of misfire Misfire monitoring Complete or incomplete Monitoring test of fuel system Fuel system monitoring Complete or incomplete Monitoring test of comprehensive component Component monitoring Complete or incomplete Test of catalyst Catalyst Diagnosis Complete or incomplete Test of heated catalyst Heated catalyst No support Test of evaporative emission purge control system Evaporative purge system Complete or incomplete Test of secondary air system Secondary air system No support Test of air conditioning system refrigerant A/C system refrigerant No support Test of oxygen sensor Oxygen sensor Complete or incomplete Test of oxygen sensor heater O2 Heater Diagnosis Complete or incomplete Air fuel ratio control system for bank 1 Fuel System for Bank 1 ON or OFF Engine load data Calculated load valve - Engine coolant temperature signal Coolant Temp. °C or °F Short term fuel trim by front oxygen (A/F) sensor Short term fuel trim B1 % Long term fuel trim by front oxygen (A/F) sensor Long term fuel trim B1 % Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg or kPa or inHg or psig Engine speed signal Engine Speed RPM Vehicle speed signal Vehicle Speed km/h or MPH Ignition timing advance for #1 cylinder Ignition timing adv. #1 ° Intake air temperature signal Intake Air Temp. °C or °F Intake air amount signal Mass Air Flow g/s EGR signal EGR System No support Throttle position signal Throttle Opening Angle % Rear oxygen sensor output signal Oxygen Sensor #12 V Air fuel ratio correction by rear oxygen sensor Short term fuel trim #12 % On-board diagnostic system OBD System - Front oxygen (A/F) sensor equipment Oxygen sensor #11 Supported Oxygen sensor equipment Oxygen sensor #12 Supported Front oxygen (A/F) sensor output signal A/F Sensor #11 V
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL. - A list of the support data is shown in the following table.