Front Strut: Installation
WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
- Install strut mount at upper side of strut to body and tighten with nuts.
Tightening torque:
20 N.m (2.0 kgf-m, 14.5 ft-lb)
- Position aligning mark on camber adjustment bolt with aligning mark on lower side of strut.CAUTION:
- While holding head of adjusting bolt, tighten self-locking nut.
- When self-locking nut is removed, replace with a new one.
Tightening torque:
152 N.m (16 kgf-m, 112 ft-lb)
- Install ABS sensor harness to strut.
Tightening torque:
32 N.m (3.3 kgf-m, 23.9 ft-lb)
- Install bolts which secure brake hose to strut.
Tightening torque:
32 N.m (3.3 kgf-m, 23.9 ft-lb)
- Install wheels.NOTE: Check wheel alignment and adjust if necessary.