Body & Frame: Seats: Seats: General Description: Caution

Be sure to perform the system calibration for occupant detection system after seat installation, when the passenger seat has been removed or even one installing bolt for front passenger seat has been loosened. < Ref. to SYSTEM CALIBRATION , OPERATION, Subaru Select Monitor.> Failure to do so may cause improper activation of passenger's airbag.
Never disassemble the seat cushion frame assembly and slide rail, remove the occupant detection control module and each load cell sensor, or disconnect the harness connector, since the occupant detection control module, each load cell sensor and harness of occupant detection system (passenger's seat only) are installed as seat frame assembly.
When removing the front seat from a vehicle equipped with side airbag, follow cautions given in the airbag section. < Ref. to CAUTION , General Description. >