FixVault
Home › Subaru › 2006 › Forester X, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission 4AT (Diagnostics) › Subaru Select Monitor › Operation › Clear Memory Mode

Clear Memory Mode

  1. On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
  2. On the «System Selection Menu» display screen, select the {Transmission Control System} and press the [YES] key.
  3. Press the [YES] key after the information of transmission type is displayed.
  4. On the «Transmission Diagnosis» display screen, select the {Clear Memory} and press the [YES] key.
  5. When "Done" is shown on the display screen, turn the Subaru Select Monitor and ignition switch OFF.
NOTE:
  • If {Clear Memory 2} is selected and performed, DTC and learned control memory are cleared. If Clear Memory 2 is performed, execute the advance operation of learning control. <Ref. to FACILITATION OF LEARNING CONTROL  OPERATION, SUBARU SELECT MONITOR . >
  • For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".
About FixVault