Operating Cylinder: Installation
- Apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and operating cylinder.
- Install in the reverse order of removal.
Before installing the operating cylinder, apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and operating cylinder.
Tightening torque:
T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)
NOTE:- Be sure to install the clutch hose with the mark side facing upward.
- Be careful not to twist the clutch hose during installation.
- After bleeding air from the operating cylinder, ensure that the clutch operates properly.
<Ref. to CLUTCH FLUID AIR BLEEDING . >