Control Valve Body: Installation

Check the control valve body for dirt and dust.
Temporarily install the control valve body to transmission.
Install the oil cooler pipe.
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Identifying Oil Cooler Pipe
Tighten the bolts evenly.
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 2: Identifying Transmission Ground Bolts
Connect the control valve connector.

Fig 3: Identifying Control Valve Connector
Attach the magnet at specified position of oil pan.

Fig 4: Identifying Oil Pan
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)

Fig 5: Identifying Oil Pan Mating Surface
Apply liquid gasket fully to three holes other than screw holes on transmission case.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)

Fig 6: Locating Oil Pan Tightening Bolts
Install the oil pan with tightening bolts evenly.
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)
Pour ATF into the oil charge pipe.
Recommended fluid: < Ref. to HYDRAULIC CONTROL AND LUBRICATION , SPECIFICATION, General Description. >

Fluid capacity: Fill the same amount of fluid drained from drain plug hole.
Bleed the air from control valve. < Ref. to AIR BLEEDING OF CONTROL VALVE . >
Check the level of ATF. < Ref. to AUTOMATIC TRANSMISSION FLUID . >
Perform the advance operation of learning control.
< Ref. to FACILITATION OF LEARNING CONTROL , OPERATION, Subaru Select Monitor. >