Side Retainer

NOTE: After adjusting the drive pinion backlash and tooth contact, remove and install the oil seal and O-ring.

Remove O-ring.

Fig 1: Identifying O-ring
Remove oil seal.

Fig 2: Identifying Oil Seal
Take out either split pin, remove claw.
ST 398527700 PULLER ASSY

Fig 3: Identifying Either Split Pin
Securely attach two claws to outer race, set ST to side retainer.
ST 398527700 PULLER ASSY

Fig 4: Identifying Shaft And Claw
Return removed claw to the original position, and install pin and split pin.
Hold the shaft of ST to avoid removing from side retainer, and then remove the bearing outer race.
ST 398527700 PULLER ASSY

NOTE: Replace bearing inner and outer races as a single unit.

Fig 5: Identifying Shaft And Side Retainer