FixVault
Home › Subaru › 2006 › Impreza Outback Sport, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - Engine (Diagnostics) (H4SO) › Subaru Select Monitor › Operation › How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  2. Connect the diagnosis cable to Subaru Select Monitor.
  3. Insert the cartridge into Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  4. Connect the Subaru Select Monitor to data link connector.
    1. Data link connector located in the lower portion of instrument panel (on driver's side).
      Fig 3: Locating Data Link Connector Location
      G04998012
    2. Connect the diagnosis cable to data link connector.
      CAUTION: Do not connect scan tools except for Subaru Select Monitor and general scan tool.
  5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor power switch to ON.
    Fig 4: Identifying Monitor Power Switch
    G04998016
  6. Using the Subaru Select Monitor, call up DTC and various data, then record them.
About FixVault