FixVault
Home › Subaru › 2006 › Impreza WRX STi › Repair and Diagnosis › Engine Performance › System › Engine Controls - Engine (Diagnostics) (STI) › Subaru Select Monitor › Operation › How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  2. Connect the diagnosis cable to Subaru Select Monitor.
  3. Insert the cartridge into Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  4. Connect the Subaru Select Monitor to data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 3: Locating Lower Portion Of Instrument Panel (On Driver'S Side)
      G04998012
    2. Connect the diagnosis cable to data link connector.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor power switch to ON.
    Fig 4: Identifying Power Switch
    G04999924
  6. Using the Subaru Select Monitor, call up the DTC and various data, and then record them.
About FixVault