FixVault
Home › Subaru › 2006 › Impreza WRX TR › Repair and Diagnosis (Single Page) › Accessories & Equipment › Anti-Theft Systems › Security And Locks › Security Control Unit › Procedure › Function Setting (ECM Customizing)

Function Setting (ECM Customizing)

  1. Connect the Subaru Select Monitor to data link connector.
  2. Turn the ignition switch to ON.
  3. On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
  4. On the «System Selection Menu» display screen, select the {Keyless Unit Mode} and press the [YES] key.
  5. On the «Integ. Unit mode failure diag» display screen, select the {ECM customizing} and press the [YES] key.
  6. Change the setting with UP/DOWN key and press the [YES] key.
    • List of function setting item (ECM customizing)
      FUNCTION SETTING CHART

      No. Data Initial setting value Customize setting Remarks
      1 Security Alarm Setup OFF ON Security alarm (hazard, horn) is active.
      OFF Security alarm is inactive.
      2 Alarm monitor delay setup ON   After doors are locked by keyless entry system operated, Alarm monitor starts in the following delay time.
      ON Delay time is 30 seconds.
      OFF Delay time is 0 seconds.
      3 Impact Sensor Setup OFF ON Workable when Impact Sensor Setup is set to "ON". Impact sensor is in active condition.
      OFF Impact sensor is in inactive condition. (Set Impact Sensor Setup of model without impact sensor to "OFF".)
      4 Impact sensor OFF ON Vehicle is controlled with impact sensor equipped mode. (Set it to "OFF" for the model without impact sensor. If it is set to "ON", hazard, horn or siren operates with keyless entry system operated (alarm monitor starting).)
      OFF Vehicle is controlled in impact sensor no-equipped mode.
      5 Passive Alarm OFF ON There is no function that it is automatically set to ARM without user's intentional locking (ARM).
      OFF Workable when passive arming is set to "ON".
  7. After setting, make sure that vehicle equipment is same as the setting changed in the {Current Data Display & Save}.
    CAUTION:
    • It is possible to control the original functions of vehicle when settings above are corresponded to vehicle equipment.
    • Do not change the settings except for setting above during operation of equipment setting.
    • Resetting is needed if installing a new keyless unit.
    • In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. Failure to lock the doors manually will result in a higher security risk.
    NOTE: For details concerning operation procedure, refer to the Subaru Select Monitor Operation Manual.
  8. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
About FixVault