Section 12 (Cooling System (H4SO)): Radiator: Inspection
WARNING: This page is about a different variant/trim than selected.
- Remove the radiator cap, fill the radiator with engine coolant, and then install the tester to the installation position of cap.
- In the following cases, apply a pressure of 157 kPa (1.6 kg/cm2
, 23 psi) to the radiator.
- There is coolant leaking from the radiator or its vicinity.
- There is coolant leaking from the hoses or connections.
CAUTION:- Engine should be turned off.
- Wipe engine coolant from check points in advance.
- Be careful of engine coolant from spurting out when removing the tester.
- Be careful not to deform the filler neck of radiator when installing and removing the tester.