Extension Case: Installation

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
NOTE: Install thrust needle bearing in the correct direction.
Install new gasket.
Install the extension case to the transmission case.
Tighten bolts to secure the case.
Tightening torque: 25 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 1: Identifying Extension Case To Transmission Case
Courtesy of SUBARU OF AMERICA, INC.
Install the rear vehicle speed sensor.
Tightening torque: 7 N.m (0.7 kgf-m, 5.1 ft-lb)
- MPT MODEL
  
  Fig 2: Identifying Rear Vehicle Speed Sensor And Front Vehicle Speed Sensor - MPT MODEL
  Courtesy of SUBARU OF AMERICA, INC.
- VTD MODEL
  
  Fig 3: Identifying Rear Vehicle Speed Sensor And Front Vehicle Speed Sensor - VTD MODEL
  Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly. < Ref. to INSTALLATION . >