FixVault
Home › Subaru › 2006 › Outback i, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (Diagnostics) 4AT › Subaru Select Monitor › Operation › Facilitation Of Learning Control

Facilitation Of Learning Control

  1. Shift the select lever to "P" range, and apply the parking brake.
  2. Lift-up the vehicle.
  3. Connect the Subaru Select Monitor to the data link connector, and then turn the ignition switch to ON.
  4. Perform {Clear Memory 2} using the Subaru Select Monitor. < Ref. to CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor. >
  5. Using the Subaru Select Monitor, check that there is no DTC displayed.< Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) , OPERATION, Subaru Select Monitor. >
  6. Warm-up the engine until the ATF temperature displayed on the Subaru Select Monitor reaches 60 - 90°C (140 - 194°F). < Ref. to READ CURRENT DATA , OPERATION, Subaru Select Monitor. >
  7. Shift the select lever to "R" range.
  8. Turn all switches including headlight, air conditioner, seat heater, rear defogger and etc. OFF.
  9. Wait for 30 seconds or more with the ignition key turned to OFF.
  10. When "Communication Failed!" is displayed on Subaru Select Monitor, press the brake pedal fully until the learning control promotion is completed.
  11. Turn the ignition switch to ON.
  12. Change Subaru Select Monitor to «Transmission Diagnosis» display screen.< Ref. to OPERATION , Subaru Select Monitor. >
  13. Check that the Subaru Select Monitor is returned to normal operation.
  14. Shift the select lever to "P" range, and then wait for more than 3 seconds.
  15. Shift the select lever to "R" range, and then wait for more than 3 seconds.
  16. Shift the select lever to "N" range, and then wait for more than 3 seconds.
  17. Shift the select lever to "D" range, and then wait for more than 3 seconds.
  18. Shift the select lever to "N" range, and then wait for more than 3 seconds.
  19. Slowly depress the accelerator pedal to full throttle.
  20. Slowly release the accelerator pedal completely-
  21. Start the engine, and idle it.
  22. Shift the select lever to "D" range.
  23. Start learning control promotion. At this time, the SPORT indicator light in the combination meter will start blinking at 2 Hz. When the SPORT indicator light does not blink, turn the ignition switch to OFF and repeat the procedures from step  4). When the SPORT indicator light blinking at 2 Hz goes OFF, facilitation of learning control is completed.
    NOTE: When blinking of SPORT indicator light changes from 2 Hz to 4 Hz during learning control promotion, repeat the procedure from step  4).
  24. Shift the select lever to "N" range, and then turn the ignition switch to OFF.
  25. Shift the select lever to "P" range to complete the learning control promotion.
About FixVault