FixVault
Home › Subaru › 2007 › B9 Tribeca Base › Repair and Diagnosis › Body & Frame › Door Locks › Security And Locks › Keyless Entry System › Inspection › Check Rear Gate Release Actuator Operation

Check Rear Gate Release Actuator Operation

REAR GATE RELEASE ACTUATOR OPERATION DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK REAR GATE RELEASE ACTUATOR OPERATION. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the key warning switch harness connector.
  3. Connect the Subaru Select Monitor to data link connector.
  4. Turn the ignition switch to ON.
  5. Select {Integ. unit} from main menu.
  6. Select the {Current Data Display & Save}.
  7. Check the rear gate release output signal of body integrated unit when operating the LOCK/ UNLOCK button of keyless transmitter.
 Is output signal is present when operating the transmitter LOCK/UNLOCK button? Go to step 2. Check the body integrated unit. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
2 CHECK THE CIRCUIT OF REAR GATE RELEASE ACTUATOR. 
  1. Disconnect the harness connector of body integrated unit.
  2. Disconnect the rear gate release actuator harness connector.
  3. Measure the resistance between harness connectors.

    Connector & terminal 

    (i84) No. 22 - (D140) No. 1: 

 Is the resistance less than 10 Ω? Go to step 3. Repair the harness.
3 CHECK CIRCUIT OF HAZARD LIGHT. 
  1. Check the ground circuit of rear gate release actuator
  2. Disconnect the rear gate release actuator harness connector.
  3. Measure the resistance between harness connector terminal and chassis ground.

    Connector & terminal 

    (D140) No. 2 - Chassis ground: 

 Is the resistance less than 10 Ω? Check the trunk lid lock actuator. < Ref. to INSPECTION , REAR GATE LATCH ASSEMBLY. > Repair the harness.
About FixVault