Clear Memory Mode

NOTE: To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memory 2}.

Check that the select lever is in "P" range.
On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu» display screen, select the {Transmission}.
Select the [OK] after the information of transmission type is displayed.
On the "Transmission Diagnosis" display screen, select the {Clear Memory}.
NOTE: If {Clear Memory 2} is selected and performed, DTC are not cleared.
When 'Done' and Turn ignition switch OFF are shown on the display screen, turn the ignition switch to OFF and close the Subaru Select Monitor. To turn the ignition switch to ON again, wait for more than 10 seconds.
NOTE: For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".