Check Buzzer Chirp Setting
DIAGNOSTIC PROCEDURE CHART
| Step |
Check |
Yes |
No |
1 CHECK BUZZER CHIRP SETTING.
- Check the current setting of the buzzer chirp.
- Remove the key from ignition switch.
- Close all the doors and the rear gate.
- Press the LOCK/ARM or UNLOCK/DISARM button.
|
Does the buzzer sound? |
The buzzer function is OK. |
Go to step 2. |
| 2 CHECK BUZZER CHIRP SETTING.
NOTE:
When steps 1) to 5) are performed with the answer-back buzzer setting OFF, the answer back buzzer setting is switched to ON.
- Open the driver's door, and remove the key from ignition switch.
- Turn the center door lock switch to UNLOCK, then insert the ignition key.
- Remove and insert the key five times within 10 seconds from the step 2).
- Close the driver's door within 10 seconds from the 5th of the step 3).
- Switch the answer-back buzzer setting (ON←→OFF), then hazard light will blink three times.
NOTE:
If the driver's door is not closed within 10 seconds, the hazard light blinks once. In this case, retry from the beginning.
- Press the LOCK/ARM or UNLOCK/DISARM button.
|
Does the buzzer sound? |
The buzzer function is OK. |
Check the keyless transmitter function. <Ref. to
CHECK KEYLESS TRANSMITTER BATTERY AND FUNCTION INSPECTION, KEYLESS ENTRY SYSTEM. > |