Transmission Control Device: Installation

Install the detention spring to the transmission case.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 1: Identifying Detention Spring To Transmission Case
Courtesy of SUBARU OF AMERICA, INC.
Insert the range select lever, and then tighten the bolt.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 2: Identifying Range Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Manual Plate And Parking Rod
Courtesy of SUBARU OF AMERICA, INC.
Insert the spring pin to the manual plate.

Fig 4: Identifying Spring Pin To Manual Plate
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan and the control valve assembly. <Ref. to INSTALLATION , Control Valve Body . >
Turn over the transmission case to its original position.
Install the pitching stopper bracket.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install and adjust the inhibitor switch. <Ref. to INHIBITOR SWITCH . >
Insert the inhibitor switch and transmission harness connector onto the stay.

Fig 5: Identifying Inhibitor Switch And Transmission Harness Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air breather hose. <Ref. to INSTALLATION , Air Breather Hose . >
Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:

50 - 55 mm (1.97 - 2.17 in)

Fig 6: Identifying Input Shaft Dimension
Courtesy of SUBARU OF AMERICA, INC.
Install the torque converter clutch assembly. <Ref. to INSTALLATION , Torque Converter Clutch Assembly . >
Install the transmission assembly to the vehicle. <Ref. to INSTALLATION , Automatic Transmission Assembly . >