FixVault
Home › Subaru › 2007 › Forester X, Standard › Repair and Diagnosis › External Pages › Different car › Section 79 (Security And Locks) › Keyless Entry System › Inspection › Check Buzzer Chirp Setting

Check Buzzer Chirp Setting

WARNING: This page is about a different car, the 2006 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK BUZZER CHIRP SETTING. 
  1. Check the current setting of the buzzer chirp.
  2. Remove the key from ignition switch.
  3. Close all the doors and the rear gate.
  4. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer sound? The buzzer function is OK. Go to step 2. 
2 CHECK BUZZER CHIRP SETTING. 
NOTE: When steps 1) to 5) are performed with the answer-back buzzer setting OFF, the answerback buzzer setting is switched to ON.
  1. Open the driver's door, and remove the key from ignition switch.
  2. Turn the center door lock switch to UNLOCK, then insert the ignition key.
  3. Remove and insert the key five times within 10 seconds from the step 2).
  4. Close the driver's door within 10 seconds from the 5th of the step 3).
  5. Switch the answer-back buzzer setting (ON←→OFF), then hazard light will blink three times.
    NOTE: If the driver's door is not closed within 10 seconds, the hazard light blinks once. In this case, retry from the beginning.
  6. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer sound? The buzzer function is OK. Check the keyless transmitter function. <Ref. to CHECK KEYLESS TRANSMITTER BATTERY AND FUNCTION  INSPECTION, KEYLESS ENTRY SYSTEM. >
About FixVault