FixVault
Home › Subaru › 2007 › Impreza WRX STi › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Security And Locks › Security Control Unit › Procedure › Function Setting (ECM Customizing)

Function Setting (ECM Customizing)

  1. Connect the Subaru Select Monitor to the data link connector.
  2. Turn the ignition switch to ON.
  3. On the «Main Menu» display screen, select {Each System Check}.
  4. On the «System Selection Menu» display screen, select {Keyless Unit Mode}.
  5. In the «lnteg. unit mode failure diag» display screen, select {ECM customizing}.
  6. Change the setting with the UP/DOWN keys and set with the [OK] key.
    • List of function setting item (ECM customizing)
    LIST OF FUNCTION SETTING ITEM

    No. Data Initial setting values Customize setting Remarks
    1 Security alarm setup OFF ON Security alarm (hazard, horn) activates.
    OFF Security alarm in inactive condition
    2 Alarm monitor delay setting ON   After the keyless lock operation, the alarm monitor starts after the following delay time has passed.
    ON Delay time is 30 seconds.
    OFF Delay time is 0 seconds.
    3 Impact sensor setup OFF ON Enabled when the Impact Sensor Setup is set to "ON". Impact sensor function becomes activated.
    OFF Impact sensor in inactive condition (Always set to OFF for vehicles not equipped with the sensor.)
    4 Impact sensor setup OFF ON Vehicle is controlled in impact sensor equipped mode. (Always set to "OFF' on vehicles that are not equipped with the impact sensor. When set to "ON", hazard, horn or siren will operate after doors are locked by the keyless entry system operation (Alarm monitor start).)
    OFF Vehicle is controlled in no impact sensor mode.
    5 Passive arming OFF ON Disables the feature that automatically arms even when the user does not lock (arm) intentionally.
    OFF Enabled when passive arming is set to "ON".
  7. After setting, make sure that vehicle equipment matches the changed settings in the {Current Data Display & Save}.
    CAUTION:
    • The above settings most match the actual vehicle equipment for proper operation.
    • Do not change settings other than the above while setting the functions.
    • Perform setup again when installing a new keyless unit.
    • In the passive mode, the security alarm will automatically operate, but the doors will not be locked. In this case, it is very dangerous from a security viewpoint, so care must be taken to always lock the vehicle.
    NOTE: For details concerning the operation procedure, refer to the " EXTXREF SUBARU SELECT MONITOR OPERATION MANUAL ".
  8. Turn the ignition switch to OFF, and stop the Subaru Select Monitor.
About FixVault