Fuel Pump: Installation
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Install so that the protrusion (A) of gasket is pointed towards the front of the vehicle.
- Insert the protrusion (B) of the gasket into the upper plate. (3 places)
- Align the protrusion (C) of fuel pump assembly with the cutout on the upper plate.
- Tighten the nuts to the specified torque in the order as shown in the figure.
NOTE:
Use a new gasket and a retainer.
Tightening torque: 4.4 N.m (0.45 kgf-m, 3.2 ft-lb)